Position the rebounder on the floor or a table with legs extended. To gain access to the springs and edges of the mat, you must remove the spring cover from the rebounder. This is done by pulling the “bungee” cord over each leg. Or, you can carefully pull the spring cover over the frame and slide it down the legs.
With the mat fully exposed, you will remove the old mat with a scissors or utility knife. The polypropylenematerial used for the jump surface and the edge webbing are very tough. Be cautious of your cutting tool and remain in control during the cut. Begin by cutting from the center of the mat toward and through the outer webbing. Repeat this as many times as necessary to remove the mat.
With the mat now removed, inspect the clevis pins that pass through the frame for excessive wear on the eye of the pin.
In order for the rebounder to properly close, the grain of the mat must be in line with the hinges. At left is an example of the weave of permatron. The fibers are crossed to form 2 perpendicular axes. The grain is either set of fibers.
The grain of the mat passes between 2 cleats which will attach between the 2 hinges of the rebounder.The negative grain will pass directly into 2 mat cleats.
Begin by attaching 2 springs to the mat on either side of one hinge. Move to the other hinge and do the same. You can then attach the remaining springs. (Spring replacement instructions)
Finally, lubricate the contact points between the springs and mat cleats and if necessary the point where the springs enter the Clevis Pins and replace the spring cover.
Welcome to Needak Rebounder, your trusted online store for quality Needak Rebounders. We specialise in providing a complete one stop shop for all your rebounder needs. Needak Rebounders are made in the US and are of the highest quality to ensure superior performance from other rebounders.
Obesity was one of my main concerns as I worked from home but all this was solved by a needak rebounder :)
N.Y, Tiffany Wyler, NY
Excellent for people who want a quick easy workout and lack the time to do so.